DC energy meter for direct and indirect current measurement Voltage ranges from 0-10 VDC up to 0-1500 VDC with two S0 outputs and limit
DC energy meter for direct and indirect current measurement
Voltage ranges from 0-10 VDC up to 0-1500 VDC with two S0 outputs and limit
Areas of application: Photovoltaic systems, wind power and other installations up to a
voltage of 1500 VDC.
Heed the safety information in the operating instructions!
The meter described may only be installed by qualified electrical specialists in accordance with DIN EN 50110-1/-2 and IEC 60364. Before commissioning the meter, check it for damage during transportation. The meter must not be put into service if has been damaged. When using the meter, adhere to the applicable legislation, standards and regulations. Install the meter only in dry rooms. The meter must not be installed above or on top of easily flammable materials. Non adherence to these instructions for use or any use other than as intended will result in loss of warranty. The meter is maintenance-free when used properly.